Willem eprom programmer manual 2006 install#

Jumper Setting The Jumpers are divided into 3 Groups 2.1 Group 1 - For selecting different types of EPROM, EEPROM and Flash EPROM 2.2 Group 2 For selecting 27xxx type EPROM programming voltage 2.3 Group 3 Only for or 8M memory chip 2ДЈ Once completed the Jumper setting, please follow the program instruction/hence to config the DIP switch setting before programming any chip 3.

It should shows Hardware Present in the status bar, otherwise please Check Power & connection 1Дў 2.

Willem eprom programmer manual 2006 install#

1 Universal Willem EPROM Programmer Quick Start Guide V Installation 1.1 Turn off the PC 1.2 Connect the DB25 parallel cable Male connector to PC s printer port 1.3 Connect the DB25 parallel cable Female connect to Universal Willem EPROM Programmer 1.4 Plug in the USB cable to the PC USB port 1.5 Turn on the PC 1.6 Copy the programmer software setup97ja.exe from Floppy Disk into the Hard Disk 1.7 Double click the hard disk copy of setup97ja.exe to install the programmer software 1.8 Double click the Eprom3 icon to start the program 1.9 Connect the USB Cable to the Universal Willem EPROM Programmer the Green LED should light up 1.10 Check the programmer type, change it to PCB3 if it shows Willem Select Help from the main, then click Test Hardware.